Advanced lluminated Pulsar 710 Betreibershandbuch PDF herunterladen (Seite 16)

a d v a n c e d i l l u m i n a t i o n . c o m

P u l s a r 7 1 0 M a n u a l

4.3 Pulsar 710 Status Indicator Lights:

The Pulsar 710 has three LED indicator lights. Refer to Figure 4 for an

illustration of these indicator lights.

4.3.1 Green: This light indicates that the Pulsar 710 has power either

from the USB connection to the host computer or the main 24VDC

power connection.

4.3.2 Amber: The amber light indicates the operational status of the

Pulsar 710. A blink rate of once per second indicates normal operation.

A blink rate of 5 times per second indicates an error condition.

4.3.3 Red: The red light blinks an error code in the case of an error

condition.Theconditionisindicatedbythreesetsofsequentialashes.

Forexample:4ashesfollowedby2ashesfollowedby3ashesindicates

anerrorcodeof423whichsigniesthatthemainpowerswitchisoff.

Two common error codes are:

• 351: No light head detected.

• 423: The main power switch is off.

Pulsar 710 Output Connector Pinout:

Pin Function

1 Channel 1 supply: Positive

2 Channel 1 return: Negative

3 Channel 2 supply: Positive

4 Channel 2 return: Negative

5 Channel 3 supply: Positive

6 Channel 3 return: Negative

7 Channel 4 supply: Positive

8 Channel 4 return: Negative

9  Signatech1:IdenticationResistor1

10  Signatech1:IdenticationResistor2

11 Light head detection: Connects to Pin 13 Digital Ground

12 Signatech II: EPROM data read/write

13 Digital Ground: Grounds EPROM, Light head detect

14 Power Ground: Chassis Ground, Connect cable shielding

Note: Channel returns shall not be connected to either Digital ground or

Power Ground

Table 1: Pulsar 710 output connector, pin description

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Keine Kommentare

Advanced lluminated Pulsar 710 Betreibershandbuch Seite 16