Advanced lluminated Pulsar 710 Betreibershandbuch PDF herunterladen (Seite 20)

a d v a n c e d i l l u m i n a t i o n . c o m

P u l s a r 7 1 0 M a n u a l

command. The bottom panel shows information about the Pulsar 710.

4.4.2.4 Pulsar 710 Utility Dialog Box Output Controls:

4.4.2.4.1 Select Channel: The buttons labeled 1, 2, 3, and 4 select which

channelthesettingsaretoapplyto.SynchronizeandEqualizeoptionscan

be selected by checking the appropriate box.

•Synchronize:Whenthisboxischecked,anychangeinthesettingsfor

the selected channel are added to the three unselected channels.

•Equalize:Whenthisboxischeckedthesettingsoftheselectedchannel

are applied directly to the three unselected channels.

4.4.2.4.2 Program Button: None of the settings described below

will take effect until the Pulsar 710 is programmed. Pressing the program

button will transfer the settings from the host computer to the Pulsar 710

allowing the settings to take effect. The program button will be highlighted

to indicate that there are new settings that have not yet been transferred

tothePulsar710.IfthePulsar710isashinganerrorcodeuponinitial

start up a USB time out error will be experienced when you press the

program button on the software interface. If this situation occurs, turn off

the power switch on the Pulsar 710 and program. Once the error code

isclearedthePulsar710canbeprogrammed“onthey.”

4.4.2.4.3 Mode:Oneofvemodescanbeselectedhere.

• Pulsed: The Pulsar 710 produces pulses in response to a trigger signal.

The current and timing are determined by the control settings.

• Constant: The Pulsar 710 produces a constant output. The current is

determined by the control settings. The timing settings are not available

in this mode.

• Timing Bypass: The Pulsar 710 produces pulses that follow the trigger

signal. As an example, if the trigger pulse width is set to 10u secs

the output of the Pulsar 710 will turn the light on for 10u sec. It

is important to remember that Signatech II parameters always take

precedence over input pulse width. If the selected trigger is set to

falling edge the output is inverted. The current is determined by

the control settings: The timing settings are not available in this mode.

• Gated DC: The Pulsar 710 produces a constant output that is “Gated”

by the trigger signal. If the selected trigger is set to falling edge the

output is enabled by a low signal, logic “0” on the trigger, otherwise

a high signal, logic “1” enables the output. The timing settings are not

available in this mode.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Keine Kommentare

Advanced lluminated Pulsar 710 Betreibershandbuch Seite 20