Advanced lluminated Pulsar 710 Betreibershandbuch PDF herunterladen (Seite 8)

a d v a n c e d i l l u m i n a t i o n . c o m

P u l s a r 7 1 0 M a n u a l

set between 1 and 999 microseconds in 1 microsecond increments at

pulserepetitionratesupto200Hz.

2.2 User Interface

2.2.1 Remote Operation: Remote operation via a host computer

allows the operator to make full use of the exibility offered by the

Pulsar 710. Communication is accomplished by a USB interface.

Operating parameters are set by user friendly Windows based Pulsar

710 controller software. Supported operating systems are Windows

2000 and Windows XP.

2.2.2 Local Control: Front panel controls permit the operator

to select the operating parameters under local control. Selected

parameters are stored in electrically erasable programmable read-only

memory (EEPROM).

2.3 Diagnostics

A comprehensive set of diagnostic routines and indicators are provided.

Error codes are displayed by the Pulsar 710 via LED indicators on the

frontpanel.Codedenitionsarefoundinsection6.0“Troubleshooting”

where diagnostics are covered in greater detail.

Section: 3.0 Quick Start

Thepurposeofthissectionistoallowtheoperatortoperformaquick

functional test. This will permit an easy checkout of the Pulsar 710 and

attached light head for proper operation.

3.1 Pulsar 710 Controller Cable Connections:

Twophysicalcableconnectionswillbe requiredtooperatethePulsar

710 and light head in self test mode. Figure 1 shows the front panel of

the Pulsar 710.

3.1.1 Power:The Pulsar 710 requires an external 24 volt supply for

operation. A power cable is provided. Plug the 2 pin connector into the

socket labeled “VDC INPUT”. Observe the polarity markings on the

panel below the VDC INPUT socket. Refer to section 4.2.1 for more

details regarding the 24 volt supply.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Keine Kommentare

Advanced lluminated Pulsar 710 Betreibershandbuch Seite 8