Advanced lluminated Pulsar 710 Betreibershandbuch PDF herunterladen (Seite 18)

a d v a n c e d i l l u m i n a t i o n . c o m

P u l s a r 7 1 0 M a n u a l

4.4.2 Running under Host Computer Control

4.4.2.1 Congure Pulsar 710: Set the power switch on the Pulsar 710

to the “off” position. Using Figure 1, locate the four section dip switch

that sets the operating mode. Set the four switches to 0000 (MODE 0).

Logic “1” is set when the switch is up and Logic “0” is set when the switch

is down. If you haven’t done so already, connect the host computer to the

Pulsar 710, using the supplied USB cable. Set the power switch to “on”.

There will be no output from the Pulsar 710 to the light head on startup.

All parameters will now be controlled by the host computer.

Figure 8: Software installation, program group

Figure 7: Software installation, destination folder

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Keine Kommentare

Advanced lluminated Pulsar 710 Betreibershandbuch Seite 18